ATSC: Bookings & Resources
Home | Labs & Studios | DigFab Lab | Staff | Bookings & Resources: Bookings
Booking
- Read and understand the instructions in the Laser Cutter guidelines prior to booking the laser cutter.
- All users should be present 15 minutes prior to booking periods
- Any issues or questions can be emailed to: atsc@sydney.edu.au
- Use the schedule below to book your session, by clicking the box corresponding to the date and time you wish to book either laser cutter.
Please use the correct template and check the material dimensions before booking
Alpha 810 x 450mm
Gamma & Delta 1240 x 710mm
Subject Specific Bookings: any students who are not enrolled in the specified subjects who create this booking will have their booking cancelled and can face a ban.
Students are reminded that the full booking must be paid for, even if the allotted time is only partially used. e.g. if you book 60 minutes and only use 35 minutes, you are still required pay for 60 minutes of time
Laser Cutter ALPHA |
Laser Cutter GAMMA |
Laser Cutter DELTA |
Laser for MARC4003* |
*any students who are not enrolled in the specified subjects who create this booking will have their booking cancelled and can face a ban.
Cancellations
- Cancellations MUST be notified 3 hours in advance
- Bookings must be cancelled through the Laser Cutter booking sytem
- Failure to cancel your booking more than once will result in a ban from the machines for 2 weeks