Unit of study table

Unit of study Credit points A: Assumed knowledge P: Prerequisites C: Corequisites N: Prohibition Session

Master of Professional Engineering (Power)

To qualify for the award of the Master of Professional Engineering in this specialisation, a candidate must complete 144 credit points, including core and elective units of study as listed below.

Core units

Year One

COMP9001
Introduction to Programming
6      Semester 1
Semester 2
COMP9123
Data Structures and Algorithms
6    N INFO1105 OR INFO1905 OR COMP2123 OR COMP2823
Semester 1
ELEC9602
Digital Logic
6    A This unit of study assumes some knowledge of digital data representation and basic computer organisation.
N ELEC5722
Semester 1
ELEC9703
Fundamentals of Elec and Electronic Eng
6    A Basic knowledge of differentiation & integration, and HSC Physics
N ELEC5710 OR ELEC1103
Semester 1
ELEC9103
Simulations and Numerical Solutions in Eng
6    A ELEC9703. Understanding of the fundamental concepts and building blocks of electrical and electronics circuits and aspects of professional project management, teamwork, and ethics.
N ELEC5723 OR ELEC2103 OR COSC1001 OR COSC1901
Semester 2
ELEC9302
Signals and Systems
6    A Basic knowledge of differentiation & integration, differential equations, and linear algebra.
N ELEC5721
Semester 2
ELEC9601
Computer Systems
6    A HSC Mathematics extension 1 or 2
N ELEC5711
Semester 2
ELEC9704
Electronic Devices and Circuits
6    A Ohm`s Law and Kirchoff`s Laws; action of Current and Voltage sources; network analysis and the superposition theorem; Thevenin and Norton equivalent circuits; inductors and capacitors, transient response of RL, RC and RLC circuits; the ability to use power supplies, oscilloscopes, function generators, meters, etc.
N ELEC5720 OR ELEC2104
Semester 2

Year Two

ENGG5202
Sustainable Design, Eng and Mgt
6    A General knowledge in science and calculus and understanding of basic principles of chemistry, physics and mechanics
Semester 1
ENGG5204
Engineering Professional Practice
6    A Competences and experience in engineering obtained during an accepted engineering degree
Semester 1
Complete 24 credit points from the Foundation units block across Year Two.
Select 12 credit points from Electrical Elective units or Management Elective units.
Candidates complete 48 credit points from Specialist units, Elective units and Management Electives across Year Two and Year Three.

Year Three

ENGG5217
Practical Experience
   N ENGP1000 OR ENGP2000 OR ENGP3000 OR ENGG4000 OR CHNG5205 OR AMME5010


Students should have completed one year of their MPE program before enrolling in this unit.
Intensive April
Intensive August
Intensive December
Intensive February
Intensive January
Intensive July
Intensive June
Intensive March
Intensive May
Intensive November
Intensive October
Intensive September
Select at least 12 credit points from the Project or Research Pathway block.
Select 36 credit points from the Specialist units block, the Elective units block or the Management Elective units block.
Candidates complete 48 credit points from Specialist units, Elective units and Management Electives across Year Two and Year Three.

Foundation units

Candidates must complete 24 credit points from the following Foundation units of study.
ELEC9203
Electricity Networks
6    A This unit of study assumes a competence in first year mathematics (in particular, the ability to work with complex numbers), in elementary circuit theory and in basic electromagnetics.
N ELEC3203 OR ELEC5732
Semester 1
ELEC9204
Power Electronics and Applications
6    A Differential equations, linear algebra, complex variables, analysis of linear circuits. Fourier theory applied to periodic and non-periodic signals. Software such as MATLAB to perform signal analysis and filter design. Familiarity with the use of basic laboratory equipment such as oscilloscope, function generator, power supply, etc.
P ELEC9704
N ELEC5733
Semester 1
ELEC9206
Electrical Energy Conversion Systems
6    A ELEC9203. Following concepts are assumed knowledge for this unit of study: familiarity with circuit theory, electronic devices, AC power, capacitors and inductors, and electric circuits such as three-phase circuits and circuits with switches, the use of basic laboratory equipment such as oscilloscope and power supply.
N ELEC5734
Semester 2
ELEC9304
Control
6    A Specifically the following concepts are assumed knowledge for this unit: familiarity with basic Algebra, Differential and Integral Calculus, Physics; solution of linear differential equations, Matrix Theory, eigenvalues and eigenvectors; linear electrical circuits, ideal op-amps; continuous linear time-invariant systems and their time and frequency domain representations, Laplace transform, Fourier transform.
N ELEC5735
Semester 2

Specialist units

Candidates must complete 36 credit points from the following Specialist units of study.
ELEC5203
Topics in Power Engineering
6    A ELEC3203 Power Engineering and ELEC3204 Power Electronics and Drives.Familiarity with basic mathematics and physics; competence with basic circuit theory and understanding of electricity grid equipment such as transformers, transmission lines and associated modeling; and fundamentals of power electronic technologies.
Semester 2
ELEC5204
Power Systems Analysis and Protection
6    A The unit assumes basic knowledge of circuits, familiarity with basic mathematics, competence with basic circuit theory and an understanding of three phase systems, transformers, transmission lines and associated modeling and operation of such equipment.
P (ELEC3203 OR ELEC9203 OR ELEC5732) AND (ELEC3206 OR ELEC9206 OR ELEC5734)
Semester 1
ELEC5205
High Voltage Engineering
6    A The following previous knowledge is assumed for this unit. Circuit analysis techniques, electricity networks, power system fundamentals.
P (ELEC3203 OR ELEC9203 OR ELEC5732) AND (ELEC3206 OR ELEC9206 OR ELEC5734)
Semester 2
ELEC5206
Sustainable Energy Systems
6    A Following concepts are assumed knowledge for this unit of study: familiarity with transformers, ac power, capacitors and inductors, electric circuits such as three-phase circuits and circuits with switches, and basic electronic circuit theory.
Semester 2
ELEC5207
Advanced Power Conversion Technologies
6    A ELEC3204
Semester 2
ELEC5208
Intelligent Electricity Networks
6    A Fundamentals of Electricity Networks, Control Systems and Telecommunications
Semester 1
ELEC5211
Power System Dynamics and Control
6    A The assumed knowledge for learning this UoS is a deep understanding on circuit analysis and its applications in power system steady state analysis.
P ELEC3203 OR ELEC9203 OR ELEC5732
Semester 1
ELEC5212
Power System Planning and Markets
6    A The assumed knowledge for learning this UoS is power system steady state analysis
P ELEC3203 or ELEC9203 OR ELEC5732
Semester 2

Elective units

Candidates may complete up to 12 credit points from the following Elective units of study.
ELEC5508
Wireless Engineering
6    A Basic knowledge in probability and statistics, analog and digital communications, error probability calculation in communications channels, and telecommunications network.
Semester 2
ELEC5511
Optical Communication Systems
6    A (ELEC3405 OR ELEC9405) AND (ELEC3505 OR ELEC9505). Basic knowledge of communications, electronics and photonics


-
Semester 1
ELEC5512
Optical Networks
6    A Knowledge of digital communications, wave propagation, and fundamental optics
Semester 2
ELEC5514
Networked Embedded Systems
6    A ELEC3305 AND ELEC3506 AND ELEC3607 AND ELEC5508
P ELEC5509
Semester 2
ELEC5516
Electrical and Optical Sensor Design
6    A Math Ext 1, fundamental concepts of signal and systems, fundamental electrical circuit theory and analysis
Semester 1
ELEC5616
Computer and Network Security
6    A A programming language, basic maths.
Semester 1
ELEC5620
Model Based Software Engineering
6    A A programming language, basic maths.
Semester 2

Management Elective units

Candidates may complete up to 12 credit points from the following Management Elective units of study.
ENGG5203
Quality Engineering and Management
6    A First degree in Engineering or a related discipline
Semester 2
ENGG5205
Professional Practice in Project Management
6   

This is a core unit for all Master of Professional Engineering students as well as all students pursuing Project Management studies (including Master of Project Management, Graduate Certificate in Project Management and Graduate Diploma in Project Management). No prerequisite or assumed knowledge.
Semester 1
Semester 2
ENGG5214
Management of Technology
6    A Sound competence in all aspects of engineering, and some understanding of issues of engineering management
Semester 2
ENGG5215
International Eng Strategy and Operations
6    A Sound competence in all aspects of engineering, and some understanding of issues of engineering management and globalisation
Semester 2
ENGG5216
Management of Engineering Innovation
6    A Sound competence in all aspects of engineering, and some understanding of issues of engineering management
Semester 1

Project units

All candidates are required to complete a minimum of 12 credit points of Project or Research units during the final year of study.
Candidates achieving an average mark of 70% or higher over 48 credit points of units of study in the Year Two Table or equivalent are eligible for the Extended Capstone Project.
Extended Capstone Project candidates take Capstone Project units ELEC5020 and ELEC5022 (total 18 cp) in place of Capstone Project ELEC5021 and 6 cp of elective units.
ELEC5020
Capstone Project A
6    P 96 cp from MPE degree program or 48 cp from the MPE(Accel) program or 24 cp from the ME program (including any credit for previous study).
Semester 1
Semester 2
ELEC5021
Capstone Project B
6    C ELEC5020
N ELEC5022 OR ELEC5222 OR ELEC5223

Note: Department permission required for enrolment

Semester 1
Semester 2
ELEC5022
Capstone Project B Extended
12    P 24 credit points in the Master of Engineering and WAM >=70, or 96 credit points in the Master of Professional Engineering and WAM >=70 or 48cp from MPE(Accel) program and WAM >=70
N ELEC5021 OR ELEC5222 OR ELEC5223

Note: Department permission required for enrolment

Semester 1
Semester 2

Research pathway

Candidates achieving an average mark of 75% or higher over 48 credit points of units of study in the Year Two Table or equivalent are eligible for the Research Pathway.
Research pathway candidates take Dissertation units ELEC5222 and ELEC5223 (total 24 cp) in place of Capstone Project units and 12 cp of elective units.
ELEC5222
Dissertation A
12    N ELEC8901 or ENGG5223 or ENGG5222 or ELEC8902

Note: Department permission required for enrolment
In order to enrol in a project, students must first secure an academic supervisor in an area that they are interested. The topic of your project must be determined in discussion with the supervisor. The supervisor can come from any of the Engineering Departments, however, they need to send confirmation of their supervision approval to the Postgraduate Administrator.
Semester 1
Semester 2
ELEC5223
Dissertation B
12    N ELEC8901 or ELEC8902 or ENGG5222 or ENGG5223

Note: Department permission required for enrolment
In order to enrol in a project, students must first secure an academic supervisor in an area that they are interested. The topic of your project must be determined in discussion with the supervisor. The supervisor can come from any of the Engineering Departments, however, they need to send confirmation of their supervision approval to the Postgraduate Administrator.
Semester 1
Semester 2

Exchange units

Exchange units require the approval of the Program Director. With approval, up to 12 credit points of Exchange units may taken in place of other units, towards the requirements ofthe degree.
ELEC6901
Electrical Exchange Unit 1A
6      Intensive January
Intensive July
Semester 1
ELEC6902
Electrical Exchange Unit 1B
12      Intensive January
Intensive July
Semester 1
ELEC6903
Electrical Exchange Unit 1C
24      Semester 1
ELEC6904
Electrical Exchange Unit 2A
6      Intensive January
Intensive July
Semester 2
ELEC6905
Electrical Exchange Unit 2B
12      Intensive January
Intensive July
Semester 2
ELEC6906
Electrical Exchange Unit 2C
24      Semester 2

For more information on degree program requirements visit CUSP (https://cusp.sydney.edu.au).